- Industry: Government
- Number of terms: 35337
- Number of blossaries: 0
- Company Profile:
Cloud consisting of numerous minute water droplets and based at the surface; droplets are small enough to be suspended in the earth’s atmosphere indefinitely. (Unlike drizzle, it does not fall to the surface. Fog differs from a cloud only in that a cloud is not based at the surface, and is distinguished from haze by its wetness and grey color.)
Industry:Aviation
Airspace designated under 14 CFR part 73 within which the flight of aircraft, while not wholly prohibited, is subject to restriction.
Industry:Aviation
Landing gear employing a third rear-mounted wheel. These airplanes are also sometimes referred to as tailwheel airplanes.
Industry:Aviation
Areas consisting of airspace of defined vertical and lateral dimensions established at locations where there is a requirement for increased security and safety of ground facilities. Pilots are requested to voluntarily avoid flying through the depicted NSA. When it is necessary to provide a greater level of security and safety, flight in NSAs may be temporarily prohibited. Regulatory prohibitions are disseminated via NOTAMs.
Industry:Aviation
Wingtip vortices that are created when an airplane generates lift. When an airplane generates lift, air spills over the wingtips from the high pressure areas below the wings to the low pressure areas above them. This flow causes rapidly rotating whirlpools of air called wingtip vortices or wake turbulence.
Industry:Aviation
The energy applied to an object that attempts to cause the object to change its direction, speed, or motion. In aerodynamics, it is expressed as F, T (thrust), L (lift), W (weight), or D (drag), usually in pounds.
Industry:Aviation
The VOR needle appearing to indicate the reverse of normal operation.
Industry:Aviation
Flight with a minimum disturbance of the forces maintaining equilibrium, established via effective control use.
Industry:Aviation
The initial tendency of an aircraft to continue away from the original state of equilibrium after being disturbed.
Industry:Aviation
The boundary area formed when a warm air mass contacts and flows over a colder air mass. Warm fronts cause low ceilings and rain.
Industry:Aviation
